Got my install done finally. The instructions that come with the kit are excellent, so I only did a couple of pictures...
1.) Built a bit of a cradle to hold the shaker level...
2.) Figured out the correct location for the mounting and marked the area, then spread on the JBWeld...
3.) Added some weight, and because it was a little cool out ran a hairdryer on it for a while (don't tell the wife!)...
4. That was it! The JBWeld sets up pretty quick, so neatness isn't easy (or necessary I think) just make sure it doesn't get into the return springs...
My shaker was already cut open, so I didn't have to worry about that part. The instructions don't mention having to remove the metal mounting plate that connects the shaker to the carb, but I think it would be hard to do without removing it. As I was repainting my shaker anyways, drilling out the rivets and remounting the plate later wasn't an issue either.
All in all it was a simple process, and the whole thing works great. Again, the instructions are excellent so just following them it should be easy for any back-yard handyman/woman to do, just take your time.