Author Topic: Tail stoplights/turnsignal/hazard (Read 2980 times)

soldier79ta · « **on:** August 31, 2006, 10:30:06 AM »

Just wanted to know if anyone had any; brakelight, turn signal, hazard light problems in the past. For some reason those lights on the R/R of my T/A are non-op. The parking lights do work. Any ideas out there?

Hitman · « **Reply #1 on:** August 31, 2006, 10:34:02 AM »

First thing I would do is replace the light bulbs, or at least switch them from side to side for a test. If you swap the bulbs and they still do not work, then check the wiring. Start at the tail lights and work your way forward. There has also been know out there for tilt steering columns for the wires to get pinched in the steering column itself.

kyledyr · « **Reply #2 on:** August 31, 2006, 05:16:40 PM »

Check the fuses?

It fixed my problem.

ta78w72 · « **Reply #3 on:** August 31, 2006, 07:23:30 PM »

I'm with Brett....check the bulbs. I had this problem about four years ago. I read the manual and was convinced my turn signal cam was bad. But on a whim, I replaced my passenger front turn signal bulb. Everything worked after that. However, my problem was limited to the turn signals. The hazard lights and turn signal lights are connected. I'm not sure if the brake lights are connected to the hazard light switch or not.

Eagle 1 · « **Reply #4 on:** September 01, 2006, 10:23:55 AM »

Check for any rust or corrosion build up inside the light socket.