This is a little lengthy so bear with me, I've replaced the resistor, relay, now switch, It still will only run in a high position and will not shut off
till I turn the switch off and flip the blower switch off and back to high it then goes off.
I took a picture of the terminal that connects to the blower switch, the loose wire far left I can jump a wire from it and get four different speeds
one is very slow seemingly the one that should run when the switch is on, then i can get low, med, high as I go to each terminal .
I thought for sure it was a switch problem so I replaced it with a new switch but I have the same problem, any help would be appreciated.