Author Topic: PS Fluid  (Read 3860 times)

0 Members and 1 Guest are viewing this topic.

Offline good 'ol bird

  • Jr. Member
  • *
  • Posts: 13
PS Fluid
« on: August 06, 2006, 06:59:43 PM »
Posted this over at country with no response:

I recently purchased a 79 6.6 / WS6 with 72k miles. The power steering fluid appears to be old (probably original) I’m looking for replacement procedure advice.

I also assume it (steering) would take standard dextron ATF, am I correct?

Thanks in advance for the help….

Mark
_________________
79 Atlantis Blue TA
403 Olds 72k
t tops WS6
very clean
979 403 WS6

Offline eroc022

  • Lifetime Member
  • *****
  • Posts: 7655
PS Fluid
« Reply #1 on: August 06, 2006, 08:16:38 PM »
best way to do it and cleanest...take off the pump and resivoir and turn upside down...also replace your lines at the same time....turn steering wheel both ways to clean out the fluid in the steering box....and reassemble with new fluid....tranny should take dexron mercon unless you have a shift kit or sometihng like that and then it would be better to use type f
Eroc
Fixing the car that Restore A Muscle Car jacked up....

Offline good 'ol bird

  • Jr. Member
  • *
  • Posts: 13
PS Fluid
« Reply #2 on: August 07, 2006, 05:32:02 PM »
:D thanks again eroc
979 403 WS6

Offline Hitman

  • Administrator
  • Lifetime Member
  • *****
  • Posts: 8284
    • http://www.78ta.com
PS Fluid
« Reply #3 on: August 07, 2006, 07:19:30 PM »
Try reading this as well, it might help a little:

http://www.78ta.com/steering.htm
Brett Campbell
"Hitman"
www.78ta.com
1978 Trans Am

Offline good 'ol bird

  • Jr. Member
  • *
  • Posts: 13
PS Fluid
« Reply #4 on: August 07, 2006, 10:44:52 PM »
yep, read that one too, thanks

I thought there might be a procedure like....remove hose, use pump to pump out system, replace lines if required, refill with dex type 2, blead system, close hood.

The new car syndrome hasn't wore of yet, Anality on my part is still a miner problem :roll:

Mark
979 403 WS6