Hitman's Pontiac Trans Am Forum
Trans Am Information => Aftermarket Questions => Topic started by: meltdown on September 29, 2016, 04:52:01 PM
-
Hi Guys,
Can stock 1980 Firebird headlight wiring handle 9003(H4) 60w Bulbs?
Thanks!
-
It can handle it but you'll need to rotate the wiring on the plug as the lighting is different.
-
Thanks!
That was my next question!
Is this diagram correct?
(http://i86.photobucket.com/albums/k105/78transammeltdown/4656toH4Conversion_zpsc218c1a0.jpg)
Thanks again...
-
That's the one, doesn't hurt to double check.
-
Agreed!
Thanks again
-
Hey Aus78Formula,
I need to pick your brain again if you dont mind....
I did the pin swap on the 2 outside light plugs as shown on the diagram..BUT....
I am having a problem where BOTH passenger side headlights are on ALL the time when the headlight switch is pulled (hi-beam & lo-beam stay on no matter what)
Also, on the drivers side, the 'main' headlight (not the hi-beam) is dim & turns OFF when the hi-beam switch is turned on.
Lastly, the hi-beam on the drivers side NEVER turns on.
Any ideas??
What the heck am I missing?
(Just a note, but all lights worked fine before I decided to upgrade to 9003 bulbs)
Thanks!
***UPDATE!! SOLVED: PROBLEM WAS BACK GROUNDING WIRE ON DRIVERS SIDE 'MAIN' LAMP!!**