Author Topic: Rewiring buzzer on a new seat belt  (Read 62 times)

0 Members and 1 Guest are viewing this topic.

Online Crisis

  • Jr. Member
  • *
  • Posts: 30
  • Referrals: 0
Rewiring buzzer on a new seat belt
« on: October 10, 2017, 05:09:10 PM »
Hello,

I don't know if it's the right place to post this new topic... hope it's good here.
So, i'm in a restauration project of a 79 T/A and I'm about to replace the old seat belts by a new set.
The new set haven't any wiring for the buzzer/alarm/light when belt isn't buckled.
How to wiring the new set (the driver belt) to let the buzzer/light working ? Is it possible?

I've bought this set : https://www.summitracing.com/int/parts/rtb-rb-7481cmb/overview/

Thank you everybody =)

Offline Aus78Formula

  • Adv. Member
  • ****
  • Posts: 1934
  • Referrals: 0
Re: Rewiring buzzer on a new seat belt
« Reply #1 on: October 11, 2017, 02:11:32 AM »
I'd say very likely not possible with new set as originals had different receivers for each side, one that had plastic insulated sections that would only ground when buckled. It only saves 2 sec anyway, and most simply don't hook up.

Online Crisis

  • Jr. Member
  • *
  • Posts: 30
  • Referrals: 0
Re: Rewiring buzzer on a new seat belt
« Reply #2 on: October 11, 2017, 06:42:16 AM »
Sad news...  :'(

But thank you Aus78'