Guys I am still having trouble getting my 403 running again. The car was idling one day in my drive way and then just quit. A month or so before that I had changed out the plugs, wires, cap, and rotor. Everything was running fine for several weeks. Now I have fire at the batt side of the distributor but nothing at the plugs. I have checked more than one plug also. Nothing.
Since this problem started, I have changed out:
module
pickup coil
ignition coil (2 different ones have been tried)
condenser & harness assembly
distributor cap (again)
rotor (again 2 different ones tried here also)
There is nothing else inside the distributor that I can change out. I am stumped at this point. Is there anything outside the distributor that would cause the plugs not to fire. I tested the batt side terminal of the distributor while the engine is turning over with the starter and my test light stays lit. I checked with a volt meter and am getting 10.8 volts to the distributor. Should be plenty to fire the engine but still no fire at the plugs. What else would cause my plugs not to fire with power going into the distributor? Can anyone give me some hints with this please?