Pages: [1]   Go Down

Author Topic: control arms  (Read 3086 times)

0 Members and 1 Guest are viewing this topic.

Offline bad76

  • Member
  • **
  • Posts: 235
control arms
« on: February 23, 2007, 08:53:06 AM »
Does anyone have any info on where I could buy aftermarket tubular upper and lower control arms?
Logged

Offline O'Neall

  • Sr. Member
  • ***
  • Posts: 503
  • T-tops? We don't need no stinkin' T-tops!
control arms
« Reply #1 on: February 23, 2007, 12:00:42 PM »
Pro-Touring F-body http://www.pro-touringf-body.com has them for about as reasonable a price as I've seen.

Also, you can get them from Global West and Hotchkis.
Logged
Jon O'Neall
1977 Y81 Trans Am
W72-400/Auto (1 of 549)
"Trans Am!  What's your pleasure?"

Offline bad76

  • Member
  • **
  • Posts: 235
control arms
« Reply #2 on: February 26, 2007, 02:17:38 PM »
I will check pro touring f body and I checked with Hotchkis and they do not make them for my car yet.
Logged

Offline O'Neall

  • Sr. Member
  • ***
  • Posts: 503
  • T-tops? We don't need no stinkin' T-tops!
control arms
« Reply #3 on: February 26, 2007, 02:19:50 PM »
Tell him I sent ya!  :wink:
Logged
Jon O'Neall
1977 Y81 Trans Am
W72-400/Auto (1 of 549)
"Trans Am!  What's your pleasure?"

Offline eroc022

  • Lifetime Member
  • *****
  • Posts: 7655
control arms
« Reply #4 on: February 27, 2007, 07:02:31 PM »
heidts is next after pro touring in price...399 a set and you have a choice of 1" narrowed or factory dimensions...if your going any wider than an 8.5" wheel on the front then youll need narrowed...
Logged
Eroc
Fixing the car that Restore A Muscle Car jacked up....

Offline 79T/Aman

  • Member
  • **
  • Posts: 415
    • http://www.pro-touringf-body.com
Re: control arms
« Reply #5 on: March 14, 2007, 09:04:41 AM »
we do have control arms for second gen cars the only thing is that the lowers are for use with QA1 coil overs.
Logged

Offline bad76

  • Member
  • **
  • Posts: 235
Re: control arms
« Reply #6 on: March 27, 2007, 04:14:41 PM »
I decided against the aftermarket control arms, way to expensive. I had my stock arms blasted and powder coated, I replaced the ball joints and installed a set of urethane bushings.   
Logged
Pages: [1]   Go Up