Getting close to finishing up Pat's dash bezel, lower right plate and heater/AC bezel, here are some progress pics, have about three hours left on the project with machining, clear coating, and reassembling, will look good as new when completed.....
Before Pics (Not in too bad of shape, typical oxidation, faded pattern in a few areas and the usual "yellowed" clear coat from exposure to the elements over the years..no surface rust or pits!!!!!!!!!!
After Sanding process: 80 grit, 120 grit, 180 hand sand, 220 grit, 320 hand sand.......
After the Polishing Process....two step....wiped down with laquer thinner, ready to be machined!
Will post some progress pics later this weekend...When Completed!