OK, so while I'm trying to figure out my harmonic balancer issue (no money for that). I decided it was time to change my dashboard and my wiring harness. I have a few questions and I'm looking for some advice. No I don't have a wiring diagram....LOL My car is an 80 so it has the plastic fuses not glass. Please see below.
[/URL]
[/URL]
Now on to my questions. My replacement dash harness has a few extra things on it that my old one did not.
1. The new one I believe came from a car with a power antenna option, I think that because it had an antenna cable directly in the wiring harness itself. It also had these 2 connections that my old one did not. I think they are turbo stuff? Will they do any harm if I leave them there? They were located at the farthest end of the harness away from the fuse box itself.
2. These wires were cut in both the harness I have. They came out of the same part of the harness as the parts in the background. Does anyone know what they are for? In case the color is not good they are yellow, black and a grey.
3. Is there any reason anyone can think of that these harnesses are not interchangeable? I would hate to go through this whole process only to find out that it was a waste of time....lol
4. I want to get rid of the aftermarket gauges seen in the first pic and go back to my original stock gauges. The oil pressure gauge had a yellow wire leading out from under the dash and obviously a power and a ground. My question is what wire in the stock harness do I need to cut and splice with the yellow wire to make my stock oil pressure gauge work.
5. Along the same lines, I had a red wire leaving under the dash to the hood compartment for my aftermarket temp gauge and of course aftermarket power and ground. My question is which wire would I need to splice the red one to so my stock temp gauge will work?
THANKS FOR ANY HELP!!!!