Hitman's Pontiac Trans Am Forum
Trans Am Information => Restoration => Topic started by: PA-TA on March 22, 2019, 10:56:57 AM
-
I am changing the heater core on my 1978 Trans Am and figured while everything is apart I will also replace the blower motor. I removed the nut holding the squirrel cage on the motor but it won't come off. Before I apply too much force I thought I would ask if there are any tricks to removing this. Should it just pull off after removing the retaining nut?
-
It's just a half-round shaft and a snug fit.
-
Thanks Aus I thought so but wanted to make sure before I applied more force ;D