Pages: [1]   Go Down

Author Topic: Tired of Fisher T Tops Rattling, Im stumped!  (Read 4182 times)

0 Members and 1 Guest are viewing this topic.

Offline 78GableWS6

  • Jr. Member
  • *
  • Posts: 1
Tired of Fisher T Tops Rattling, Im stumped!
« on: September 01, 2017, 09:02:53 PM »
I swear that I remember that my T-Top latch pins use to have a plastic coating/cover on them to make a tight and non metal/metal contact when it is locked in.  Driving with bare pins means there is some hop and lift on the tops, and this may also break the seal with the window pushing up on them.
 Now of course I ignored that for 25 years now, but since I am replacing my upholstery now, its on my mind, and I finally registered for this site to solve this mystery.
I see NO mention on the internet anywhere for this, and there is no replacement ends I can find, only the grommets and tabs for the middle pillar.

Am I wrong?

Should I figure out a way to custom make some type of replacement?

78Gable

78TA WS6 4 speed, Black with Carmine interior.
Driving it daily!

Logged

Offline Burd Turd

  • Lifetime Member
  • *****
  • Posts: 3855
Re: Tired of Fisher T Tops Rattling, Im stumped!
« Reply #1 on: September 05, 2017, 07:04:03 PM »
I have a gray set that was taken off back in the 80's.  I'll look on the pins.  My 78 is prob wore off.
Logged
Born and Raised in South Detroit Bitches

Offline BanditRich

  • Member
  • **
  • Posts: 101
    • Mass Firebirds
Re: Tired of Fisher T Tops Rattling, Im stumped!
« Reply #2 on: September 08, 2017, 01:29:31 PM »
Ames Performance has these plastic clips you are looking for - part # FH519.  When I bought my TA 15 yrs ago it was missing these and this is where I got them from; and never had a rattling issue since.  ;D
Logged
Black Y88 - W72/WS6                                                            "What's a Texas county mountie doing in Arkansas? Well let's see what he's got under the hood! Bye bye baby!"
http://www.allgentransams.com/members_pages/mf/april2010.html

Offline onefunkar

  • Jr. Member
  • *
  • Posts: 33
Re: Tired of Fisher T Tops Rattling, Im stumped!
« Reply #3 on: November 26, 2017, 07:10:38 PM »
i do remember on my 77 se i put a little piece of cardboard somewhere probably the latch for rattling so they must have rattled some even when new.
Logged
wish i could have any of my 3 t/a s back.

Offline Wallington

  • Adv. Member
  • ****
  • Posts: 2640
Re: Tired of Fisher T Tops Rattling, Im stumped!
« Reply #4 on: November 26, 2017, 09:18:44 PM »
Logged

Offline 78w72

  • Adv. Member
  • ****
  • Posts: 1500
Re: Tired of Fisher T Tops Rattling, Im stumped!
« Reply #5 on: December 26, 2017, 11:45:19 AM »
this post is kind of old... but hes not talking about the plastic insert clips for the t top frames that enage the tabs at the roof, hes talking about the latch rods that engage the metal blocks when the tops are latched.  originally the rods had a thick plastic coating on them... after years of use the coating wears off. 

nobody makes a specific product for this but there are options, cheapest & easiest way is to wrap 1 or 2 layers of electrical tape on the bare metal rods, it wont last too long but will prevent metal to metal contact as described.  other option is to use plasti-dip & put a good coating on the rods... it too wont last forever but should do what you want & can be reapplied when needed. 
Logged
78 w72 ws6 4 speed
81 turbo pace car
lots of other past t/a's

Offline Burd Turd

  • Lifetime Member
  • *****
  • Posts: 3855
Re: Tired of Fisher T Tops Rattling, Im stumped!
« Reply #6 on: November 14, 2019, 06:48:44 PM »
There’s a tech bulletin for the noisy/leaking fisher t tops.  I have it. 
If you want to buy a copy pm me.   I paid a lot to get the binder $25 for the bulletin. 
Logged
Born and Raised in South Detroit Bitches
Pages: [1]   Go Up