Author Topic: Heater control vacuum hookups  (Read 7035 times)

0 Members and 1 Guest are viewing this topic.

Offline fb_rider

  • Member
  • **
  • Posts: 481
  • Referrals: 0
Heater control vacuum hookups
« on: May 07, 2006, 07:08:23 AM »
In the process of putting my dash back in, it appears that one of my vacuum tubes going into the heater control came out of the connector.  It is a black tube that goes into the center of the firewall.  There are about 5 holes left in the connector, so I'm not sure which one is goes into.  I see that each hole has a number on it - does anyone know which hole each tube goes in?
1977 Trans Am SE w/W72 engine (sold)
1999 Trans Am Anniversary Edition #953 (sold)
2000 Trans Am Firehawk #263

Offline fb_rider

  • Member
  • **
  • Posts: 481
  • Referrals: 0
Heater control vacuum hookups
« Reply #1 on: May 07, 2006, 10:08:58 PM »
No need for anyone to respond - I solved this issue.  What I found was that many of the pins for the connector are "dummies".  There was only one real connector left and I only had one loose wire - so even I was able to figure that one out.  Thanks.
1977 Trans Am SE w/W72 engine (sold)
1999 Trans Am Anniversary Edition #953 (sold)
2000 Trans Am Firehawk #263