Trans Am Information > Suspension

Body Bushing

<< < (2/2)

80indypace:
I think that might be too dangerous for me to attempt.  I am not very familiar with it at all.

81BlackTA:
Its really not that hard to do. When I did mine, I just did one at a time. By the way, you can buy a polyurethane set for a fraction of the cost of a complete set of factory ones. It will ride a little stiffer, but helps a bit with the handling as well.

dazeakamike:
all of yours really went that easy !? I just did mine... and let me tell you, 2 of the 4 gave me a run for my money... had to pull out both wheel wells because the boxs that hold the nuts bent up and the nut was just spinning. Lucky for me, i was able to fold the box back down with a crow bar and hold it down while it hit it with an impact gun.

Navigation

[0] Message Index

[*] Previous page