Recent Posts

Pages: [1] 2 3 ... 10
1
Restoration / Re: 77 Trans Am Rear Bumper Bracket Help....
« Last post by BigBird1977 on Today at 08:33:21 AM »
Thanks for the response.  Yes, the studs do line up between the two.  I think I just have to use the new one and try to reform it to look like mine.  Shouldn't be too bad. 
2
Restoration / Re: 77 Trans Am Rear Bumper Bracket Help....
« Last post by Aus78Formula on October 23, 2021, 11:42:09 PM »
The thin version is what the soft 76/77 rear bumpers used, upgraded for 78 with new bumper material. Doe the holes still line up to use it?
3
Restoration / Re: 77 Trans Am Rear Bumper Bracket Help....
« Last post by BigBird1977 on October 22, 2021, 09:15:50 AM »
Hey....

I ordered it from Ames Performance, part number FL581JF.
4
Restoration / Re: 77 Trans Am Rear Bumper Bracket Help....
« Last post by RENOVATIONS on October 22, 2021, 09:13:19 AM »
The brackets on my '78 look like the one on the left in the side by side.

Where did you order this from?
5
Restoration / 77 Trans Am Rear Bumper Bracket Help....
« Last post by BigBird1977 on October 22, 2021, 08:50:20 AM »
Was wondering if anyone could offer me any help here.  I found the dreaded rust on the passenger side rear bumper bracket.  I ordered one (gm 526627) that was listed in the Trans Am parts catalog, but it turns out to be completely different than the one on my car.  Has anyone ran into this before and what are my options? I am attaching a picture of the comparison and a picture from the drivers side.  Thanks in advanced.
6
Paint and Body / Re: Hood decal 76 TA concern
« Last post by wwc on October 19, 2021, 11:59:17 AM »
That is what I thought.
7
Paint and Body / Re: Hood decal 76 TA concern
« Last post by Rockford on October 19, 2021, 07:17:48 AM »
Hmm,...that doesn't look right.  I thought perhaps it may be a result of the backing that is still attached, but I don't think so.  Looks as though there's a bit too much in the way of orange in it.
8
Paint and Body / Hood decal 76 TA concern
« Last post by wwc on October 18, 2021, 06:04:45 PM »
Ordered a gold and black hood bird for 76 TA from phoenix graphics. When it came it says gold/yellow orange/black 7378L-1. When you look at where you expect the yellow butterscotch highlight color you see a dark almost red color. When I put this on the hood will it be actually the butterscotch color? Attached are photos of what the bird should look like when applied and the decal I got.
9
Forum Help and Suggestions / Re: Can't access site on phone
« Last post by Aus78Formula on October 15, 2021, 07:52:06 AM »
cheers, Rockford
10
Forum Help and Suggestions / Re: Can't access site on phone
« Last post by Rockford on October 15, 2021, 07:35:43 AM »
Sorry to hear about your brother's passing, Aus.
Pages: [1] 2 3 ... 10