Recent Posts

Pages: [1] 2 3 ... 10
1
Paint and Body / Re: Sandblasting issue
« Last post by Aus78Formula on Today at 03:32:45 AM »
Pic too small to tell, it'd soon be covered in rusty fingerprints otherwise. And yes, sandblasting will leave somewhat of a rough surface and ideal for a good base primer to bite into. But can't tell if it has anything or not, easy to ask them. You'll be needing to clean it anyway, never know who's greasy hands have been on it prior to paint.
2
Paint and Body / Re: Sandblasting issue
« Last post by eviledolean on September 17, 2021, 12:19:25 PM »
Looks to me like they sprayed a primer on it?    I would just give them a call to fid out for Shure.
3
Shows and Events / El Paso, Arrive and Shine Car show. Every third Satuday
« Last post by eviledolean on September 17, 2021, 12:17:07 PM »
El Paso, Arrive and Shine Car show.  Every third Saturday
4
Paint and Body / Sandblasting issue
« Last post by banditt5 on September 17, 2021, 11:19:48 AM »
Just got my inner fender back for my 79 T/A from being sandblasted. I was expecting it to be bare metal, however, its covered in a very rough sandpaper like texture. Not sure if it can be seen in the image. Should I sand it down? Did they put some type of protective coating on it? Was expecting to put Eastwoods pre paint cleaner on it and use a self etching primer before painting. I'm not sure what to do with this.
5
Parts Wanted / Re: Need Carb for 78 w/ man. trans.
« Last post by Pap on September 15, 2021, 12:15:13 PM »
Not planning on it, but I'm assuming that the Pontiac engineers had a reason for using a specific carb. 
6
Trans Am Values / Re: 1977 403
« Last post by eviledolean on September 15, 2021, 11:16:12 AM »
Going to vary widely on the condition and if it is a matching numbers or highly modified car.  Some pictures would also help.
7
Electrical / Re: 1978 Trans Am engine bay wiring diagram
« Last post by Aus78Formula on September 14, 2021, 09:39:26 PM »
Sending shortly, just heading home.
8
Electrical / Re: 1978 Trans Am engine bay wiring diagram
« Last post by b_hill_86 on September 14, 2021, 08:28:51 PM »
He frequents the site still and Iím sure he still has what you need. Just give it a few or send him a PM if you havenít already. Depending on forum setting he may receive an email notification of your PM.
9
Electrical / Re: 1978 Trans Am engine bay wiring diagram
« Last post by Mooshs78TA on September 14, 2021, 04:21:19 PM »
PM me with your email, I'll send a large colour diagram. If they are all cut, you may end up well ahead also obtaining a good, used and complete harness instead. It isn't hacked up plus many of those plugs are hard to get. The plugs themselves will cost more than the harness.

I know this is a few years old but would you still happen to have that large colour diagram? If so could I trouble you for it? I'll PM you my email. Thanks in advance
10
Electrical / Re: Winsheild washer pump for 1978
« Last post by Mooshs78TA on September 14, 2021, 04:13:35 PM »
Thanks to everyone for the responses.  I ened up  ordering the pump that goes on the washer jar with a new washer jar and hoses and wired it to the original  motor on the firewall. and it works.
Pages: [1] 2 3 ... 10