Author Topic: TVS to EFE valve vacuum line routing  (Read 171 times)

0 Members and 1 Guest are viewing this topic.

Offline blackjack76

  • Jr. Member
  • *
  • Posts: 27
TVS to EFE valve vacuum line routing
« on: September 13, 2021, 05:09:20 PM »
Does anyone know how the metal part of the vacuum line is suppose to rout. It is rubber from the TVS valve to the metal line with several bends and I would assume rubber piece again to connect to the EFE valve mounted to exhaust manifold. Does the metal line go over the driver side valve cover then down or come from around back of valve cover and to EFE. Does it go around  back of the head and over the manifold heat shield. Just wondering if anyone knows.

Offline blackjack76

  • Jr. Member
  • *
  • Posts: 27
Re: TVS to EFE valve vacuum line routing
« Reply #1 on: September 14, 2021, 03:03:03 PM »
Thanks if you read the post but I was able figure out how the metal vacuum line piece came around the  back of valve cover over the heat shield and connected again to the EFE valve with another short piece of vacuum hose. Must be some little clamp or bracket missing to hold the tube in place.