Topic: DIY: Power window 4 relay setup (w/pictures)

[formula1le]

To check the motor you must take a single battery lead and with the motor connector unplugged, jump one terminal then the other but not both at the same time-this should get the motor going up/down. If not, make sure the door shell is well grounded and retry. If it still doesnt go, motor most likely is bad.

[Wallington]

Yes, ground the door and add live to up or live to down.

[lee01]

Photobucket gate, so I lost many good picture
There atleast the wiring diagram I made back then
Hope this help

[pwrcat4000]

Stupid Photobucket!

[Wallington]

I don't understand how you can lose pictures, but it's a mammoth task to re upload them using another host and match the content. I did that with a few, far easier to start from scratch or just delete topic. This one only needed the final electrical diagram so is still useful.

[pwrcat4000]

Thanks for editing and re posting that

[Dinero]

I ran a wire straight from the battery then I put the wire one at a time on each connector on the motor. The window flys up and down but when I put the connecter back on, the window does not move. I have checked wiring and I see no issues . The other window works fine. I have new window switch and pigtail connector also but that did not solve the problem for the passenger side window.