Vendors and Distributors > Phoenix Graphix

Decals just won't stick

(1/10) > >>

N PRGRES:
Cleaned the surface good with wax remover and the little pillar birds just will not come off of the top clear paper.  THe bigger decals had no issues but these little guys just will not separate, I need to call PG tomm and see if they will replace them.

joe d:
RENOVATIONS may have a solution to that take a deep breath

RENOVATIONS:
I put the decal in place with gel...press out the gel/bubbles...let sit for an hour or so...and use a small pull area of the paper (if it doesn't separate, try another pull area on the paper (use a very low angle of pull).
It does help if the paper is slightly damp.

If you have no luck, they may very well be defective but I haven't run across any yet that wouldn't separate

N PRGRES:

--- Quote from: RENOVATIONS on March 11, 2012, 01:20:50 PM ---I put the decal in place with gel...press out the gel/bubbles...let sit for an hour or so...and use a small pull area of the paper (if it doesn't separate, try another pull area on the paper (use a very low angle of pull).
It does help if the paper is slightly damp.

If you have no luck, they may very well be defective but I haven't run across any yet that wouldn't separate

--- End quote ---
I have tried every pull area I can and it won't release ;(

joe d:
just might be a defect Dave. That sucks

Navigation

[0] Message Index

[#] Next page