Author Topic: Roundin off bleeder valve...  (Read 2098 times)

0 Members and 1 Guest are viewing this topic.

Offline Marlin1977

  • Jr. Member
  • *
  • Posts: 5
Roundin off bleeder valve...
« on: July 15, 2018, 09:55:00 PM »
trying to bleed my brakes, I rounded off the valve. It probable hasn't moved in years. I can't get it off with vice grips. What can I do?

Online Aus78Formula

  • Adv. Member
  • ****
  • Posts: 2505
Re: Roundin off bleeder valve...
« Reply #1 on: July 16, 2018, 07:18:12 PM »
Where is it?

Offline Nexus

  • Lifetime Member
  • *****
  • Posts: 3018
Re: Roundin off bleeder valve...
« Reply #2 on: July 17, 2018, 03:13:23 AM »
Heat is about the only way you'll get it off...Want to heat the calliper (disc brakes) / wheel cylinder (drum brakes) more then the bleed screw...this will expand the metal around the bleed screw and should be good to get the screw to move with the vice grips. Worst case scenario, you'll have to heat the brake line (unless they are new), remove it and then remove the calliper / wheel cylinder and do it on the bench. Sometimes it's easier and way less frustrating to just replace it all with new parts (when you can afford it) and start from there. All the brake components work then. I live in the north and everything rusts up and gets seized. Done this job lots of times on various vehicles.

you don't need a big cutting torch and a propane torch may work...heat combined with shocking the metal with a cold wet rag will also help too. Sometimes I have done several combinations of things.

1979 - Making a T/A Clone and starting with higher than normal optioned Esprit (20 years and counting)